Robert's 32H Paul FHub & Word Disc Hubs on Salsa 29er Race Delgado Rims

We built these for customer Robert's custom Independent Fabrication Single-Speed 29er.

Paul black 32H FHub disc 100 front hub

Paul black 32H Word Disc 135mm rear hub

Salsa Race Delgado 29er black disc rims

3 cross pattern

DTSwiss stainless steel black spokes and black (brass) nipples.

• Spokes for the rear drive side (no disc) = 16 x 293 mm



• Spokes for the rear non-drive side (disc) = 16 x 293 mm



• Spokes for the front (non disc)  = 16 x 293mm



• Spokes for the front (disc)  = 16 x 292mm

* Remember: If you are used to building non-disc front bike wheels, disc front wheels use different spokes lengths for each side. If you build road bike wheels or mountain bike wheels with rims that accept caliper, cantilever, or V brakes, you can usually assume the 100mm front hub measurements will allow you to use the same length of spoke for both sides of the wheel. (The front hub has the same left and right center-to-flange measurements, and there is no dish to the front wheel, since there are is no cassette or freewheel.) So, check all your hub measurements when you are building front disc hubs.

Photo taken by Wheelgirl